Installation Instructions

External GPS | NSS Installation Manual

Transducer adapter cables

For vessels with existing transducers that do not have the Navico blue 7 pin connector, there

are two adapter cables available to assist with installation.

For vessels that already have a transducer that was used with older Navico products that has 6

pin connector. Use 000-00022-001 6 pin to 7 pin transducer adapter cable.

These transducers will require the 10 k temp version of the transducer selected for transducer

type in Echo Installation. See “Echosounder setup” on page 22 for further information.

Blue 7 pin connector

6 pin connector

Connector Pins

(Front View)

Connector Pins

(Front View)

0.7 m (28”)

For other transducers that do not have Navico blue 7 Pin or 6 pin (above) connector that

require the connector to be removed. Use 000-10046-001 7 pin to bare wire adapter cable.

Not all transducers are compatible with NSS or BSM-1. Refer to the transducer type selection

list in the Echo Installation page to see if your transducer is mentioned for the selected echo

source. If not contact your Simrad dealer or Simrad Technical Support for assistance with

transducer compatibility. Simrad always recommends using Simrad transducers.

1. Red Depth +

Wire color

Function

Blue 7 pin connector

Connector Pin

Connector Pins

(Front View)

5. Black Depth -

6. Shield Depth Gnd.

2. Blue Speed signal

3. Orange Speed volts

4. Yellow Temp +

7. Shield Temp -

NSS_IM_EN_988-10107-003.indd 21 20/08/2013 4:55:47 p.m.