Specifications

Video
The video function allows you to view videos or camera sources on your NSS evo2.
Ú
Note: The video images will not be shared via the network. You can only view the video on the
unit connected to the video source.
If a FLIR camera is available on the Ethernet network, you can display the video and control
the camera from the NSS evo2.
For information about how to connect the camera, see the separate NSS evo2 Installation
manual.
The Video panel
A video panel can be set up as a single panel, or as one of the panels on a multiple panel
page.
The video image will be proportionally scaled to fit into the video panel. Area not covered by
the image will be colored black.
Setting up the video panel
Video source
NSS evo2 supports two video input channels. You can select to view one channel only, or to
cycle the image between available video cameras.
The cycle period can be set from 5 to 120 seconds.
Video standard
NSS evo2 supports NTSC and PAL video. The two channels are set up individually. Check the
local video standard or the standard of your cameras.
Adjusting the video image
You can optimize the video display by adjusting the video image settings. The settings are
adjusted individually for each video source. Default for all settings: 50%.
FLIR camera control
When the connection is established to a FLIR camera, the menu will change to include
access to FLIR camera controls.
Ú
Note: You can take over camera control from any NSS evo2 connected to the Ethernet
network.
Establishing connection with the FLIR video camera
When a video panel is active, the NSS evo2 will automatically recognize a Flir camera if this is
available on the network.
Ú
Note: When there is DHCP server present on the Ethernet network, FLIR camera will need to be
configured and set to have Static IP Address before the connection can be established. For
instructions on how to configure your specific FLIR camera model please refer to FLIR
documentation.
15
Video| NSS evo2 Operator Manual
89