Installation manual

Simrad PI54
168
851-165187 / Rev.A
Simrad 38/200 Combi D
Connect the transducer as described in the wiring diagram.
→ Simrad 38/200 Combi D (W814E), page 158
1 In the Echosunder setup dialogue, use the circular
selector pad to move the cursor (inverse video) to the
Transducer 1 / Type location.
2 Press the + button repeatedly until the setting reads
Simrad Combi 38&200.
3 Press the ENT key to save the setting and exit.
You can easily return to this setup page later, but DO NOT alter
the transducer setting unless you replace the transducer.
Simrad 50/200 Combi C
Connect the transducer as described in the wiring diagram.
→ Simrad 50/200 Combi C (W814D), page 157
1 In the Echosunder setup dialogue, use the circular
selector pad to move the cursor (inverse video) to the
Transducer 1 / Type location.
2 Press the + button repeatedly until the setting reads
Simrad Combi 50&200.
3 Press the ENT key to save the setting and exit.
You can easily return to this setup page later, but DO NOT alter
the transducer setting unless you replace the transducer.
Simrad 50/200 Combi D
Connect the transducer as described in the wiring diagram.
→ Simrad 50/200 Combi D (W814F), page 159
1 In the Echosunder setup dialogue, use the circular
selector pad to move the cursor (inverse video) to the
Transducer 1 / Type location.
2 Press the + button repeatedly until the setting reads
Simrad Combi 50&200.
3 Press the ENT key to save the setting and exit.
You can easily return to this setup page later, but DO NOT alter
the transducer setting unless you replace the transducer.