Operation Manual
Table Of Contents
- AP300X INSTRUCTION MANUAL
- FRONT MATTER
- GENERAL INFORMATION
- Introduction
- How to use this manual
- System components
- Optional components
- NI300X NMEA Interface Unit
- CI300X Compass Interface
- Rudder" indicator
- Compass" Indicator
- CDI35 Course Detector Interface
- LF3000 Linear Feedback
- LFI3000 Linear Feedback Interface
- Robnet cables
- R3000X Remote Control
- S100 NFU steering lever
- S3 NFU steering lever
- JP300 Jack Point
- Mounting brackets
- Top mount bezel
- Flush mount bezel
- AP300X AUTOPILOT OPERATION
- Overview
- AP300X with MSD50 Stern Drive unit
- ON/OFF / Standby mode
- Automatic Steering
- Navigating with the AP300X
- Wind vane steering
- Automatic Speed selection
- Multiple station system
- Lock function
- The User Set-up Menu
- AP300DLX Main features
- Operation of Graphic Display
- Waypoints
- Routes
- Navigating with the AP300DLX
- Glossary
- INSTALLATION
- General
- RF300 Rudder feedback installation
- Junction unit installation
- Drive unit installation
- Control unit installation
- RFC35 Fluxgate Compass installation
- JP300 Jack Point installation
- R3000X Remote Control installation
- S3 NFU Lever installation
- S100 NFU Lever installation
- Interfacing
- Software Setup Procedure
- Sea Trial
- MAINTENANCE
- TROUBLE SHOOTING
- TECHNICAL SPECIFICATIONS
- AP300X AUTOPILOT SPARE PARTS LIST

Technical Specifications
22081814H 121
6.4 RFC35 Fluxgate compass
Supply and output: ...............Polarity independent 2-wire supply with
superimposed pulse width modulation
Automatic Performance:
Calibration: ............. Automatically activated by control head
Gain compensation: ..... Automatically adjusted continuously
Repeatability: ..................................................................... +/- 0.5 degrees
Roll/Pitch: ........................................................................... +/- 35 degrees
Accuracy: .................................................. +/- 3 degrees after calibration
Cable supplied: ........................................................... 15 m shielded cable
Temperature range:
Operation: ..................................... 0 to +70 °C (+32 to + 158 °F)
Storage: ......................................... -40 to +80 °C (-40 to +176 °F)
Environmental Protection: ...................................................................IP56
Mounting: ....................................................................... Deck or bulkhead
Material: ...................................................................................... Black ABS
6.5 CDI35 Course Detector Interface
Supply and output: .............. Polarity independent 2-wire supply with
superimposed pulse width modulation
Automatic Performance:
Calibration: ............................ Automatically activated by control head
Gain compensation: .................... Automatically adjusted continuously
Repeatability: ..................................................................... +/- 0.5 degrees
Accuracy: .............. +/- 0,5°(not including errors from course detector)
Cable supplied: ..................................................... 15 m TP shielded cable
Dimensions: ......................................... 160 mm x 126 mm (6.3 in x 5 in.)
Weight: .................................................... 0,9 kg including cable (2,0 lbs.)
Power consumption: .................................................................... 0,9 watts
Temperature range:
Operation: ..................................... 0 to +70 °C (+32 to + 158 °F)
Storage: ......................................... -30 to +80 °C (-22 to +176 °F)
Environmental Protection: .................................................................. IP56
Mounting: ....................................................................... Deck or bulkhead
Material: ...................................................................................... Black ABS