Operation Manual

Robertson AP300X Autopilot
38 22081814H
The AP300DLX can access up to six different NMEA inputs and has
control for selecting which position source to use (one or two NMEA
inputs are standard dependent on the type of junction unit installed, 4
additional with optional NI300X. Incoming data is checked for status
and selected sentences of data from the selected position source are
also retransmitted on all NMEA outputs.
Graphic Display Setup
When first initializing a system using an AP300DLX control unit, it is
necessary to set up items in addition to the autopilot setup listed in the
Installation Settings Menu.
At turn on of an AP300DLX the graphic display will show the
following screen for about 5 seconds followed by the MAIN DISPLAY
(see previous page):
Magn. variation: None
Position source : GPS1
Position offset : None
AP300DLX
Software : V.R..
Access to the Graphic Display Setup menu is by pressing the following
softkeys:
PLOT
INSTR MOB INFO NAV
MAIN
ROUTE
WAYPT
GOTO
SETUP
ESC
MAIN
Magnetic Variation
ENTER
Position Correction
Waypoint Database
Instruments
Plot interval
SETUP
Use or  to select menu item and press ENTER.