Operation Manual

Autopilot Operation
22081814H 53
• Adding from the prevoiusly stored waypoints to the route list.
• Pressing "Enter" after creating the complete route.
Note ! The MOB waypoint and TEMP-WP may not be used as part of a route.
Flashing Cursor prompt
Move cursor out of name field to
proceed to next menu.
Edit the route name here.
Use a unique name that
identifies the route
Repeat Steps 1 and 2 for each
waypoint that will be added to
the route.
Route Name
Press Enter only when finished
adding waypoints to the route
list.
Waypoint gets
added at pointer
in Route List
You must press ENTER after creating a route to save it to memory.
WEST EAST
NORTH
00
PLOT INSTR
MOB
INFO
NAV
ROUTE - 00
ROUTE - 01
ROUTE - 02
ROUTE - 03
ROUTE - 04
ROUTE - 05
ROUTE - 06
ROUTE - 07
ROUTE - 08
ROUTE - 09
Route info:
Name: Route -00
Start: NONE
End: NONE
Next: - - - -
Select
route
ESC ADD
EDIT
Selected
Route:
GOTO
MAIN
The next available route is automatically
presented as the new route.
1.
Turn
to move pointer to waypoint
that will be inserted into route.
Robertso
n
Use the or to move
cursor to character field.
If you make an ERROR, refer to the
opposite page: "Correction of routes"
PORT
STBD
Press ADD to add
the chosen waypoint
to the route list
2.
Edit
Route
Name
Move cursor
< or >
Change value
ESC DEL
MAIN
Route - 00
ESC
DEL
MAIN
Canal 1
MOB - WP
TEMP - WP
Canal 1
Buoy 26
LP Bay
Nassau22
Jessup17
Noyack16
XXXX - 008
XXXX - 009
A
DD ENTE
R
Peconic 1
Use to select characters
for route name
Roberts on
N 40°52.60'
W 72°30.15'
MAIN
GPS1 POSITION
COG : 075°M SOG : 5.00Kt
ROUTE
WAYPT
GOTO
SETUP
Use the course selector to point at the first waypoint in the waypoint
list that will be added to the route list. Then press the ADD key.
Each time you press the ADD key, the waypoint selected in the
waypoint list will be added to the route list, and the WP insert pointer
will be set below the last waypoint that was added to the new route.