Operation Manual
Table Of Contents
- AP300X INSTRUCTION MANUAL
- FRONT MATTER
- GENERAL INFORMATION
- Introduction
- How to use this manual
- System components
- Optional components
- NI300X NMEA Interface Unit
- CI300X Compass Interface
- Rudder" indicator
- Compass" Indicator
- CDI35 Course Detector Interface
- LF3000 Linear Feedback
- LFI3000 Linear Feedback Interface
- Robnet cables
- R3000X Remote Control
- S100 NFU steering lever
- S3 NFU steering lever
- JP300 Jack Point
- Mounting brackets
- Top mount bezel
- Flush mount bezel
- AP300X AUTOPILOT OPERATION
- Overview
- AP300X with MSD50 Stern Drive unit
- ON/OFF / Standby mode
- Automatic Steering
- Navigating with the AP300X
- Wind vane steering
- Automatic Speed selection
- Multiple station system
- Lock function
- The User Set-up Menu
- AP300DLX Main features
- Operation of Graphic Display
- Waypoints
- Routes
- Navigating with the AP300DLX
- Glossary
- INSTALLATION
- General
- RF300 Rudder feedback installation
- Junction unit installation
- Drive unit installation
- Control unit installation
- RFC35 Fluxgate Compass installation
- JP300 Jack Point installation
- R3000X Remote Control installation
- S3 NFU Lever installation
- S100 NFU Lever installation
- Interfacing
- Software Setup Procedure
- Sea Trial
- MAINTENANCE
- TROUBLE SHOOTING
- TECHNICAL SPECIFICATIONS
- AP300X AUTOPILOT SPARE PARTS LIST
Robertson AP300X Autopilot
76 22081814H
• Hold the Control unit in place by hand and mark the 4 holes for the
fixing screws on the mounting surface.
• Remove the Control unit, drill the 4 mounting holes in the
mounting surface.
• Unbolt the temporarily fitted bracket halves and screw them to the
mounting surface.
• Assemble the complete bracket again and adjust the control head to
best viewing angle and tighten up the mounting bracket bolts.
• Connect the Robnet cables to the control unit connectors
Figure 3-6 AP300CX Bezel
top mounting
Figure 3-7 AP300DLX Bezel top
mounting
• Use the supplied AP300/AP300DL BEZEL MOUNTING CUT-OUT
template to make the exact cut out for the connectors. Fasten the
bezel to the panel by the 4 (6) countersunk screws. (Numbers in
brackets are for AP300DL).
• If watertight mounting is required, add some silicon around the
mounting bezel flange before mounting.
• Carefully tighten the screws making sure the bezel is not bent.
• Set the large "O-Ring" around the inside lip of the control head
mounting flange.
• Connect the Robnet cables to the control unit connectors.
• "Snap" the Control unit into the bezel mount.