Operation Manual
Table Of Contents
- AP300X INSTRUCTION MANUAL
- FRONT MATTER
- GENERAL INFORMATION
- Introduction
- How to use this manual
- System components
- Optional components
- NI300X NMEA Interface Unit
- CI300X Compass Interface
- Rudder" indicator
- Compass" Indicator
- CDI35 Course Detector Interface
- LF3000 Linear Feedback
- LFI3000 Linear Feedback Interface
- Robnet cables
- R3000X Remote Control
- S100 NFU steering lever
- S3 NFU steering lever
- JP300 Jack Point
- Mounting brackets
- Top mount bezel
- Flush mount bezel
- AP300X AUTOPILOT OPERATION
- Overview
- AP300X with MSD50 Stern Drive unit
- ON/OFF / Standby mode
- Automatic Steering
- Navigating with the AP300X
- Wind vane steering
- Automatic Speed selection
- Multiple station system
- Lock function
- The User Set-up Menu
- AP300DLX Main features
- Operation of Graphic Display
- Waypoints
- Routes
- Navigating with the AP300DLX
- Glossary
- INSTALLATION
- General
- RF300 Rudder feedback installation
- Junction unit installation
- Drive unit installation
- Control unit installation
- RFC35 Fluxgate Compass installation
- JP300 Jack Point installation
- R3000X Remote Control installation
- S3 NFU Lever installation
- S100 NFU Lever installation
- Interfacing
- Software Setup Procedure
- Sea Trial
- MAINTENANCE
- TROUBLE SHOOTING
- TECHNICAL SPECIFICATIONS
- AP300X AUTOPILOT SPARE PARTS LIST
Robertson AP300X Autopilot
80 22081814H
Apply a thin layer of pure Vaseline on the connector threads and make
sure the connectors are properly secured to the receptacle by the
coupling ring. The connectors are weatherproof according to IP67,
when properly installed.
Cable
pairs
Color
code
Pin Signal
1. pair Pink 5 V SYSTEM+
Grey 4 V SYSTEM–
2. pair Brown 1 Bus–
White 2 Bus+
3. pair Yellow 3 On - Off
Green 6 ALARM
HOW TO REMOVE PINS:
Extraction tool
Pull the wire
Insert tool in slot
Note ! For installations that require special cable length, contact your Robertson
distributor for information.
1
24
5
6
VIEWED FROM CABLE SIDE
3