Operation Manual
Table Of Contents
- AP300X INSTRUCTION MANUAL
- FRONT MATTER
- GENERAL INFORMATION
- Introduction
- How to use this manual
- System components
- Optional components
- NI300X NMEA Interface Unit
- CI300X Compass Interface
- Rudder" indicator
- Compass" Indicator
- CDI35 Course Detector Interface
- LF3000 Linear Feedback
- LFI3000 Linear Feedback Interface
- Robnet cables
- R3000X Remote Control
- S100 NFU steering lever
- S3 NFU steering lever
- JP300 Jack Point
- Mounting brackets
- Top mount bezel
- Flush mount bezel
- AP300X AUTOPILOT OPERATION
- Overview
- AP300X with MSD50 Stern Drive unit
- ON/OFF / Standby mode
- Automatic Steering
- Navigating with the AP300X
- Wind vane steering
- Automatic Speed selection
- Multiple station system
- Lock function
- The User Set-up Menu
- AP300DLX Main features
- Operation of Graphic Display
- Waypoints
- Routes
- Navigating with the AP300DLX
- Glossary
- INSTALLATION
- General
- RF300 Rudder feedback installation
- Junction unit installation
- Drive unit installation
- Control unit installation
- RFC35 Fluxgate Compass installation
- JP300 Jack Point installation
- R3000X Remote Control installation
- S3 NFU Lever installation
- S100 NFU Lever installation
- Interfacing
- Software Setup Procedure
- Sea Trial
- MAINTENANCE
- TROUBLE SHOOTING
- TECHNICAL SPECIFICATIONS
- AP300X AUTOPILOT SPARE PARTS LIST
Robertson AP300X Autopilot
82 22081814H
RFC35
FLUXGATE
COMPASS
JUNCTION UNIT
MAIN PCB
Heading
Sensor
*
* NON POLARIZED
(COLOR INDEPENDENT)
HS+
HS-
3.7 JP300 Jack Point installation
The JP300 is designed to be used in conjunction with the AP300PX
portable control units. The JP300 provides the following:
• A quick and simple means of connection/disconnection of the
AP300PX at different locations on the boat.
• A means of continuing the ROBNET network in installations that
use an AP300PX portable control unit.
The JP300 includes a
watertight connector cover
which must be installed as
shown. A 32 mm (1.26” dia.)
hole needs to be drilled for
flush installation, along with
3 small screw holes. As
indicated, a watertight
sealant must be applied to
the mating surfaces of the
JP300 and the mounting
panel.
AUTO
ST BY
OFF
NAV.
AUX
DODGE
TURN
7m cable
JP300
JACKPOINT
0.5m cable
7m cable
Robnet connectors
A second JP300 may be
connected to this cable
AP300PX
CONTROL UNIT
AP300CX/AP300DLX
CONTROL UNIT