Operation Manual
Table Of Contents
- AP300X INSTRUCTION MANUAL
- FRONT MATTER
- GENERAL INFORMATION
- Introduction
- How to use this manual
- System components
- Optional components
- NI300X NMEA Interface Unit
- CI300X Compass Interface
- Rudder" indicator
- Compass" Indicator
- CDI35 Course Detector Interface
- LF3000 Linear Feedback
- LFI3000 Linear Feedback Interface
- Robnet cables
- R3000X Remote Control
- S100 NFU steering lever
- S3 NFU steering lever
- JP300 Jack Point
- Mounting brackets
- Top mount bezel
- Flush mount bezel
- AP300X AUTOPILOT OPERATION
- Overview
- AP300X with MSD50 Stern Drive unit
- ON/OFF / Standby mode
- Automatic Steering
- Navigating with the AP300X
- Wind vane steering
- Automatic Speed selection
- Multiple station system
- Lock function
- The User Set-up Menu
- AP300DLX Main features
- Operation of Graphic Display
- Waypoints
- Routes
- Navigating with the AP300DLX
- Glossary
- INSTALLATION
- General
- RF300 Rudder feedback installation
- Junction unit installation
- Drive unit installation
- Control unit installation
- RFC35 Fluxgate Compass installation
- JP300 Jack Point installation
- R3000X Remote Control installation
- S3 NFU Lever installation
- S100 NFU Lever installation
- Interfacing
- Software Setup Procedure
- Sea Trial
- MAINTENANCE
- TROUBLE SHOOTING
- TECHNICAL SPECIFICATIONS
- AP300X AUTOPILOT SPARE PARTS LIST
Robertson AP300X Autopilot
86 22081814H
Databox/J300X
RX1
RX1+
J300X JUNCTION UNIT
MAIN PCB
DATABOX (NMEA Input)
Vbat+
Spare
Gnd
Red
Wh
Bn
Gn Blk
TX1
TX1+
NMEA
Output
BRN
BLK
INPUT +
INPUT
WHITE
BLACK
INPUT +
INPUT
GRN
WHT
RED
SOUNDER
INPUT
COMPASS
INPUT
RADIO NAV
INPUT
NMEA BUS
TO
REPEATERS
DATALINE/IS11
DATABOX
*
J300X JUNCTION UNIT
POWER P CB
TB8
TB9
TB10
RX2
RX2+
NAV. RECEIVER
OR PLOTTER
NMEA
Input2
TX2
TX2+
NMEA
Outp ut2
TWISTED PAIR
CABLE
*
RX1+
RX1
TX1
TX1+
Radar Clock/Data
J300X JUNCTION UNIT
POWER PCB
Radar
TB8
TB9
TB10
Data_h
Data_c
Clk_h
Clk_c
ANRITSU
OR
FURUNO
RADAR
DATALINE Instrument installation
The DATALINE Instruments (RUDDER, COMPASS) are designed for
panel mount in exposed locations. See separate installation description
enclosed with the units.
RX1
RX1+
JUNCTION UNIT
MAIN PCB
DATABOX (NMEA Input)
Vbat+
Spare
Gnd
Red Wh
Bn
Gn
Blk
TX1+
NMEA
Output2
TX1
GREEN
RED
BLACK
WHI
TE
TX1
TX1+
Gnd
Vbat+
DATALINE/IS11
COMPASS OR RUDDER
Note ! You can only connect the instrument as shown if the Mains input is 12 V. If
Mains has a 24 V or 32 V source a separate 12 V source must be provided
for the instrument Vbat+ and Gnd input.