Operation Manual

Robertson AP300X Autopilot
88 22081814H
NOT IN USE
WHI T E
GRE EN
SIGN.
RET.
SIGN.
RET.
GREEN
WHITE (YEL)
RED
BLACK
Furuno
ANRITZU
FURUNO
RADAR
DISPLAY
+12V
EXTERNAL
DATALINE
DATABOX
STAND ALONE
DATALINE INSTRUMENTS
RUDDER, COMPASS OR
WAYPOINT
RX+
RX-
TX+
TX-
DataH
DataC
N.C.
Clk H
Clk C
RX+
RX-
TX+
TX-
RX+
RX-
TX+
TX-
RX+
RX-
TX+
TX-
+
_
12V DC
OUT
RED
BLACK
DATALINE INSTRUMENTS
LORAN C
OUTPUT FOR RADAR,
INSTRUMENTS ETC.
ROBCHART
90/100/200
MAX 250 mA
SIGN.
RET.
WHI TE
GREEN
GPS
12 V EXTERNAL
12 V EXTERNAL
NMEA2
NMEA3
NMEA4
NMEA1
A+
B-
NOT IN USE
TERMINALS LOCATED TO THE EXTREME
LEFT AND RIGHT ON THE PCB ARE NOT IN USE
The NMEA 1-4 ports are identical in HW and SW and can be
connected as desired.
LF3000 Linear Feedback
Note ! The rod of the LF3000 is not locked in place in the cylinder. If caution is not
exercised it may slip out of its housing and end up over the side, so be
careful!
The LF3000 is a waterproof feedback unit. It has a 300 mm (11,8")
stroke and comes with a special mounting bracket which secures the
LF3000 to the cylinder of the existing outboard drive unit.
The 8,5 m (28') cable is terminated in the LFI3000 Linear Feedback
Interface according to the wiring diagram.
Center the drives. Loosely secure the LF3000 to the supplied mounting
bracket, across the center of the drive unit cylinder. Either cylinder
may be used if there is a dual set up. You may mount the feedback in
either direction, i.e. the shaft of LF3000 may point to port or starbaord.