Operation Manual
Table Of Contents
- AP300X INSTRUCTION MANUAL
- FRONT MATTER
- GENERAL INFORMATION
- Introduction
- How to use this manual
- System components
- Optional components
- NI300X NMEA Interface Unit
- CI300X Compass Interface
- Rudder" indicator
- Compass" Indicator
- CDI35 Course Detector Interface
- LF3000 Linear Feedback
- LFI3000 Linear Feedback Interface
- Robnet cables
- R3000X Remote Control
- S100 NFU steering lever
- S3 NFU steering lever
- JP300 Jack Point
- Mounting brackets
- Top mount bezel
- Flush mount bezel
- AP300X AUTOPILOT OPERATION
- Overview
- AP300X with MSD50 Stern Drive unit
- ON/OFF / Standby mode
- Automatic Steering
- Navigating with the AP300X
- Wind vane steering
- Automatic Speed selection
- Multiple station system
- Lock function
- The User Set-up Menu
- AP300DLX Main features
- Operation of Graphic Display
- Waypoints
- Routes
- Navigating with the AP300DLX
- Glossary
- INSTALLATION
- General
- RF300 Rudder feedback installation
- Junction unit installation
- Drive unit installation
- Control unit installation
- RFC35 Fluxgate Compass installation
- JP300 Jack Point installation
- R3000X Remote Control installation
- S3 NFU Lever installation
- S100 NFU Lever installation
- Interfacing
- Software Setup Procedure
- Sea Trial
- MAINTENANCE
- TROUBLE SHOOTING
- TECHNICAL SPECIFICATIONS
- AP300X AUTOPILOT SPARE PARTS LIST
Installation
22081814H 89
Loosen the end bolt (a) used to secure the cylinder to the drive unit
mount. Insert the rod retaining assembly (b) (end plate) and retighten this
bolt. Secure the feedback rod to the end plate using the two washers
and cap nut provided. Adjust the location of the LF3000 Linear
Feedback to allow full travel of the hydraulic cylinder without causing
the endplate of the LF3000 hitting the end of the cylinder. Check that
the outboard motor can be tilted freely. Tighten all nuts and the
mounting bracket.
Turn the helm slowly by hand to the stops on either side, making sure
that the rod does not bind up in any direction. Also, clamp cable to
allow full engine movement to port and starboard. The mounting
hardware provided with this system is meant to interface with Teleflex
HC5340 cylinders and Hynautic K7 and K10 Cylinders. If you are
attempting to interface to another system the hardware enclosed may
not be appropriate! Contact your dealer to obtain the correct mounting
kit.
LF3000
BRACKET
CYLINDER
JUNCTION UNIT
MAIN PCB
RF
RF+
Rudder
Feedb.
LFI3000
LINEAR FEEDBACK
INTERFACE
TB1
White
Brown
TB2
White
Brown
Green
Yellow
b
a