Operation Manual
Table Of Contents
- AP300X INSTRUCTION MANUAL
- FRONT MATTER
- GENERAL INFORMATION
- Introduction
- How to use this manual
- System components
- Optional components
- NI300X NMEA Interface Unit
- CI300X Compass Interface
- Rudder" indicator
- Compass" Indicator
- CDI35 Course Detector Interface
- LF3000 Linear Feedback
- LFI3000 Linear Feedback Interface
- Robnet cables
- R3000X Remote Control
- S100 NFU steering lever
- S3 NFU steering lever
- JP300 Jack Point
- Mounting brackets
- Top mount bezel
- Flush mount bezel
- AP300X AUTOPILOT OPERATION
- Overview
- AP300X with MSD50 Stern Drive unit
- ON/OFF / Standby mode
- Automatic Steering
- Navigating with the AP300X
- Wind vane steering
- Automatic Speed selection
- Multiple station system
- Lock function
- The User Set-up Menu
- AP300DLX Main features
- Operation of Graphic Display
- Waypoints
- Routes
- Navigating with the AP300DLX
- Glossary
- INSTALLATION
- General
- RF300 Rudder feedback installation
- Junction unit installation
- Drive unit installation
- Control unit installation
- RFC35 Fluxgate Compass installation
- JP300 Jack Point installation
- R3000X Remote Control installation
- S3 NFU Lever installation
- S100 NFU Lever installation
- Interfacing
- Software Setup Procedure
- Sea Trial
- MAINTENANCE
- TROUBLE SHOOTING
- TECHNICAL SPECIFICATIONS
- AP300X AUTOPILOT SPARE PARTS LIST
Installation
22081814H 95
Language selection
Dependent on the software version the AP300X can present the display
in two different combinations of 5 languages:
• English, Deutsch, Francais, Espanol, Italiano (software version V. R.
1)
• English, Deutsch, Dutch, Svensk, Norsk (software version V. R. 2)
To access the language selection in the ISM:
1. Turn on the equipment and wait approx. 5 seconds.
2. Press the NAV/setup button for about 5 seconds until the display
is changed to:
English
Language
INSTALLATION
3. Turn the course selector until the language you wish to use is
displayed.
4. Leave the ISM by a press on the STBY button, or continue to next
item in the ISM by pressing STBD [>] button.
Dockside settings
The following menu items are accessible and can be set up in the
Dockside Setup Menu:
• Boat type
• Drive Unit voltage
• Rudder Feedback calibration
• Automatic Rudder test
• Transition Speed
• Master Reset of memories (only if required)
Select STBY mode and enter the ISM as
p
reviousl
y
described. Go to "Dockside
Settings" by pressing STBD [>] button.
settings?
Dockside
INSTALLATION
To access the Dockside settings, turn the course selector clockwise.
The display will show:
Displacement
Boat type:
INSTALLATION
Actual boat type is selected by turning the rotary course selector. The
options are: Displacement, Planing, Sail.
Type of boat will affect the steering parameters, and the functions
available in the autopilot system. Select appropriate boat type and
press STBD [>] button.