Operation Manual

Simrad - RS12 Operation and Installation Instructions 29
4-5-3 Enable ATIS Functionality (ATIS FUNC)
ATIS functionality can only be activated if an ATIS MMSI has been entered. See 4-5-1.
DSC SETUP
INDIV REPL▲
ATIS MMSI
►ATIS FUNC ▼
ATIS FUNC
►ON
OFF
DSC IS ON
1. Select DSC SETUP, then ATIS FUNC.
Note: It is not possible to have both ATIS ON (on) and DSC ON (on) simultaneously. If you
want to activate ATIS, you must first switch DSC off. A note on the LCD will remind you if DSC
is already ON.
2. Select ON to enable the ATIS functionality - DSC must be turned off first. The ATIS
annunciator appears on the screen.
4-6 DSC functionality options (DSC FUNC)
DSC functionality can be disabled but this is not recommended unless you are going to turn
ATIS on.
DSC SETUP
GROUP SETU▲
INDIV REPLY
►DSC FUNC ▼
DSC FUNC
►ON
OFF
ATIS IS ON
1. Select DSC SETUP, then DSC FUNC.
Note: It is not possible to have both ATIS ON (on) and DSC ON (on) simultaneously. If you
want to activate DSC, you must first switch ATIS off. A note on the LCD will remind you if ATIS
is already ON.
2. Select ON to enable the DSC functionality - ATIS (if applicable) must be turned off first. The
DSC annunciator appears on the screen.
There are two annunciators on the screen to show you the current mode: if the DSC annun-
ciator is shown, DSC is operational, if the ATIS annunciator is shown, ATIS is operational.
4-7 Response Type to LL Polling Calls (LL REPLY)
You can set the radio to respond to an LL polling request in one of three ways:
AUTO automatically replies to any incoming LL polling requests from any of your
buddies.
MANUAL choose to manually reply to any incoming buddy polling requests.
OFF ignores all incoming buddy LL polling requests.
ATIS