Operation Manual

Simrad - RS12 Operation and Installation Instructions50
radio with the central hole in each mounting bracket.
5. Use the two short M5x10 screws to screw the mounting brackets to the sides of the
radio.
6. Slide each M5x32 screw through the screw hole in the mounting bracket, then attach
the lock nut and the stopper. If your bulkhead exceeds 13 mm, the stopper nut can be
discarded if necessary.
7. Tighten the M5x32 screws until the radio is held against the rear of the bulkhead.
8. Tighten up the lock nuts to secure the installation.
Install the Microphone Bulkhead Mount
1. Hold the microphone bulkhead mount at the chosen location
and use a soft pencil to mark the screw hole positions on the
mounting surface. Ensure that the microphone curly cable will
comfortably reach this location BEFORE you drill.
2. Drill the two pilot screw holes where marked.
3. Use a short length Philips screwdriver and the set of two flat
screws, spring washers, plain washers, and nuts to secure the
microphone bulkhead mount at the location site.
4. Hang the microphone on its mount.
0.96" (24.5 mm)
0.47" (12 mm)
1.16" (29.5 mm)