User's Manual Part 1

If scanning is initiated and the handset is not on the cradle, it
will display “CRADLE”. Scanning will not start until the hand-
set has been replaced and time out after 10 seconds.
To cancel the scanning function lift the handset, alternatively
press O
N/C or 16. The display will show the last channel
scanned.
3.11.1 Dynamic Memory scan delete
If the radio repeatedly locks onto the same busy channel, this
can be removed from the Memory scan process by pressing
S
HIFT and D/W (SCAN M) while locked on that channel.
“INHIBITED” will be displayed for two seconds (Fig 3.8), after
which the scan will resume bypassing the inhibited channel. To
reset inhibited channels, please refer to section 4.1.4.
RS81/RS82 VHF
24
E04572
3.12 Adjusting backlighting
The display and keypad are backlit – to set the backlighting
level, press S
HIFT followed by ON/C.
There are six levels of lighting: “OFF”, and 1 (bright) to 5 – use
the
▲ and ▼ keys to adjust the brightness. The mode will time
out after 2 seconds, but can also be cancelled by pressing either
the O
N/C or OK key.
3.13 Handset off cradle
The RS81 can support up to two handsets. If either is lifted of
the cradle, the other will display “OCCUPIED”, unless a
response to a station-to-station intercom call is required.
NOTE If the master controller displays “OCCUPIED”, it will automat-
ically become active when lifted, as its operation overrides all
other handsets. The other handset will be locked out and will
now display “OCCUPIED” instead.
68
INT
SCAN
INHIBITED
M
Fig 3.8 - Memory scan delete