Operation Manual

20
Scan Programme mode allows a limited number of channels to be monitored. *
A minimum of two and a maximum of ten channels can be pre-selected by the
operator.
* In Europe Channel 16 is always monitored together with the user-selected
channels.
SCAN PGM
10
SCAN PGM
- -
#
INT SB
10
The set will lock on to any detected signal for
four seconds, and scanning will automatically
continue unless a handset is lifted for communica-
tion. Squelch must be set to 2 or 3.
To activate/terminate Scan Programme.
While scanning takes place, channel numbers will
not be displayed.
When a transmission is detected, the set will lock
on for four seconds and display the number of the
channel.
When a handset is lifted, the scanning stops and
goes in stand-by mode. The display will show the
last received channel.