User's Manual

If the radio locks onto a busy channel, pressing OK will manu-

ally continue the scan. All Scan will otherwise automatically

restart when the channel becomes clear.

NOTE All other stations will also show the All Scan display.

NOTE While in scan mode, normal VHF functions are not available.

To exit All Scan press 16, ON/C or lift the handset from the

cradle.

2.8.1 Dynamic All Scan Inhibit

If the radio is constantly locking onto a busy channel when

scanning, this channel can be inhibited from the scan by press-

ing Shift then 1 while locked on that channel.

The display will show “Channel Inhibited” and the channel

will no longer be included in the scan cycle.

The channel can be reinstated using the menu option described

in section 3.1.1.

2.8 All Scan mode

The scan function cycles the RS87 sequentially through each

enabled channel, pausing when a signal is detected.

Press Shift followed by 1 (Scan All) to enter All Scan Mode.

If Scan is selected while the handset is off cradle, the display

will show “Place back on cradle”. This function will be can-

celled if the handset is not returned to the cradle within 10

seconds.

The display will show “Scan All” on the display. If the radio

detects a signal, it will lock onto this and the large digits will

change to show the relevant channel number (Fig 2.7) -

Instruction Manual

Part No. E04297

INT

SCAN

ALL

Fig 2.7 - All Scan mode