Operation Manual

Parameters
133
850-164385 / Rev.C
Stabilizer
The Stabilizer button is located in the Setup menu.
When the stabilizer isactive, the transducer beam will bestabilized
electronically for roll and pitch. The beam direction will change
continuously according to the vessel’s movements, and thus be
compensated whenever the vessel is out of trim. The beam angle
will always be maintained as if referred to a “flat” water surface.
When the stabilizer is used, this will also allow you to use the PP
Filter in rough seas. This filter will give a cleaner and more stable
echo presentation.
The first example in the figure (top vessel A) indicates the sonar
beam without stabilization, while the bottom vessel (B)
indicates the stable sonar beam with the stabilization in
operation.