Operation Manual

Simrad SH80
160
850-164385 / Rev.C
Cleaning the transducer
The transducer normally needs little attention. However, the
transducer face should be inspected and cleaned whenever the
vessel is in dock.
To lower the transducer when in dock, use the hoist/lower
switch S302 in the Motor Control Unit (mounted on the gantry).
Set the switch to STOP to position the transducer at any vertical
location.
Do not use strong solvents, but a normal synthetic soap and
water. Marine growth must be carefully removed with
fine-grade sandpaper or emery paper.
Note: The transducer surface must not be painted.