User manual

The Menus sinaCAM
40 Rev.: E User Manual
9.5.2 SERVICE Menu
Figure 31: SERVICE Menu
Menu items:
 Factory Preset
– Select “Factory Preset” and push the scroll wheel to return the sinaCAM to its factory settings.
 Head Bars
– Activates test bars generated by the camera heads (current image settings apply).
 Base Bars
Activates test bars generated by the base station (image settings are without effect). The base
bars output to HD-SDI terminals 1A/1B are slightly different from those for 2A/2B, with the
1A/1B outputs displaying a white rectangular on the left, see figure below (it is gray for 2A/2B).
Note: The Base Bars test image is not output via DVI!
Figure 32: Base Bars test image with camera head 1/2 indicator field highlighted
 AutoHeadPwr
– ON = By default, the base station automatically detects if a remote camera head is connected and
activates its 18V power supply (via the camera head coax cable) accordingly.
– OFF = Auto detection is disabled, the 18V head power supply is forced into “always on” mode.
NOTICE
Do not connect any equipment other than sinaCAM camera heads to the remote head terminals while
AutoHeadPwr is set to “OFF”. The 18V supply voltage on these interfaces can damage the equipment!
Displayed system information in SERVICE menu:
 Fan State
– Indicates the status of the base station’s internal fans