User manual

sinaCAM Technical Specifications
User Manual Rev.: E 51
13. Technical Specifications
Table 10: Technical Specifications – Remote Camera Head HDC1-100
Remote Camera Head HDC1-100
Image Sensor
2/3” Single Chip Kodak CCD Sensor (RGB)
2004×1144 Pixels, Progressive Scan
Sensitivity
2000 Lux @ f 8.0 / 0 dB Gain (100 % video out)
160 Lux @ f 2.2 / 0 dB Gain (100 % video out)
Resolution
1920×1080 Pixels
Dynamic Range
13.5 f-stops
Signal/Noise Ratio
64 dB @ 0 dB Gain
Interface
CoaXPress, 75 Ω BNC Cable
Max. Cable Lengths
80 m (260 ft) with Standard BNC Cable
180 m (590 ft) with Gepco VHD1100 Cable (Option)
Lens Mount
C-mount with Flange Back Distance adjustment
Power Consumption
4.6 W max.
Operating Temperature Range
0 to 45 °C (32 to 113 °F)
Table 11: Technical Specifications – Base Unit HDC1-200
Base Unit HDC1-200
Digital Signal Processing
Single Chip DSP (dual 14-bit)
White Balance Modes
AWB: Automatic White Balance (Push to set White Balance)
3200 K, 4300 K, 5600 K, 6500 K
MAN: Manual White Balance (red and blue adjust)
Black Level
adjustable
Exposure Control
200, 400, 800 ASA
Gamma
Rec. 709, various S-Log-based settings, custom via web interface
Electronic Shutter
Full Frame, 1/50 s to 1/5000 s
Remote Head Connections
CoaXPress (via 75 Ω BNC Cable)
Output Signals
up to 4× HD-SDI (SMPTE 292M, 372M)
DVI (Digital Monitor Output 1920×1080 @ 60 Hz)
HD-SDI Video Formats
YCbCr 4:2:2 / 10 bit
1920×1080 / 24p, 24psf, 25p, 25psf, 50i, 30p, 30psf, 60i,
48pDL*, 50pDL*, 60pDL*, 23.98p, 23.98psf, 29.97p, 29.97psf,
59.94i, 59.94pDL*
* = HD-SDI Dual-Link Mode
With May 2012 firmware update:
1280×720 / 24p, 25p, 30p, 50p, 60p, 23.98p, 29.97p, 59.94p
3D Monitoring
CAM1, CAM2, Alternate Frame, Alternate Line,
Subtract, Anaglyph
Synchronization
Internal or GenLock to Tri-Level Sync or Black Burst