Installation Guide

PREPARE THE CABINET

● Farmhouse sink may require custom cabinetry. We recom-

mend consulting an experienced cabinet maker for assistance.

Providing the cabinet maker with the actual sink that is to be

installed will ensure a custom fit.

● Allow clearance for the water supply lines, drains and a

garbage disposal, if applicable. Build a support frame or install

support bars from front to back along the inner sides of the

cabinet. The frame must support the weight of the sink and all

attachments.

● The support frame should be positioned so that when

installed, the sink is in line and level with the top of the

cabinet.

TEMPLATE AND CUTOUT

● No template is provided since each sink will vary dimensional-

ly. After centering the sink, trace the outline of the sink on the

counter-top with a pencil to use as a guide for the cutout.

Remember to allow clearance for any faucets and/or

backsplashes. Cut the counter-top accordingly.

FINAL PLACEMENT

●

Test ft the sink in the opening that was created in the

previous steps. The entire weight of the sink should be

supported by the support frame. Verify that the sink is in line

and level with the top of the cabinet. Use shims, if needed, to

level the sink.

Set the sink and apply your sealant to fill in any gaps below the

sink front, and between the sink and counter-top . Hold the

sink in place to secure. Place the counter-top onto the sink and

remove any excess sealant from all surfaces.