User's Manual

13
Before Using the Machine
7. Ventilation
Caution
- Use the machine in a place with good ventilation.
Do not block vents. Inappropriate cooling may lead to high temperatures inside the machine.
- In general, a new machine may produce small amount of gaseous components, so ensure good
ventilation when the machine is used for the first time. If the machine is in operation for an
extended time, do not stay in the same room for a long time.
- Basically, it is recommended to expand the supply and exhaust facilities or install a ventilation
device such as a fan at the 3D printer installation site .
- It is recommended to use indoor ventilation as follows.
Indoor ventilation
(ventilation device)
1. Considering the indoor space area, use an indoor ventilation fan with an appropriate
capacity
2. Ventilation fans are operated before the 3D printer is operated, and at least 1 hour
after the 3D printer is completed.
3. Do not completely seal the door while the fan is running, but keep the door slightly
open.
4. Use of a ventilator is carried out with natural ventilation.
Indoor ventilation
(natural ventilation)
1. In spring and autumn, open windows (5~20cm) considering the outside air.
2. In summer and winter, windows and doors are opened for 5 minutes immediately after
the 3D printer is operated, and ventilation is required for 5 minutes or more every hour.
3. After the 3D printer is finished, open the printer door and ventilate for at least 30
minutes
►Natural ventilation is performed considering whether polluted external air is flowing
in depending on the surrounding environment and atmospheric conditions.
- 3D printer during operation are recommended for industrial dust masks to wear
Intake Outtake