User's Manual

15
Before Using the Machine
③
CAUTION
Any changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
④ This product has the certification issued under the authority of the FCC by one of
Certification Body.
FCC ID : 2AB83-A1SD
 ⑤
IC Compliance
This Class [A] digital apparatus complies with Canadian ICES-003.
Cet appareil num rique de la classe [A] est conforme la norme NMB-003 du Canada.
❖ Wireless LAN Specifications
This wireless machine may be affected by electromagnetic interference so it should not be used for
life saving services.
This notice applies only to models with a Wifi module.
❖ WLAN Notice
Exposure to radio frequency radiation:
The following notice is applicable if your printer has a wireless network card installed.
The radiated output power of this device is far below the FCC radio frequency exposure limits.
A minimum clearance of 20 cm (8 inches) must be maintained between the antenna and any persons
for this device to satisfy the RF exposure requirements of the FCC.
❖ Power Consumption
Here is the table showing the power consumption of the product.
Mode Description Power Consumption (W)
Printing The machine is printing using electronic input data. 500W
Standby The machine is in standby mode.
60W (Heater OFF)
160W ((Heater ON)
Power Off The power plug is plugged into the outlet but the
machine is power off.
Lower than 0.5W
The above power consumption is the hourly average value.
Instant power consumption can be much higher than the average value.
Note
- You can set the time for machine to become power saving mode automatically.
For more information, please refer to ‘Energy Saving’ in ‘2. UI Menu Function’.
❖ Deactivated Mode
The machine consumes power even in the deactivated mode. Unplug the power cord to completely
stop the power consumption.
❖ Total Energy Usage
It would be useful to calculate the Total energy usage of the machine.
Since the electricity bill is charged in Watt unit, you have to multiply time spent in each mode by power
consumption in order to calculate the energy use.
Total energy usage is the sum of energy used in each mode.