User's Manual

Chapter 4. Error Handling
4-6
2）If the card does not come out despite continue
to turning knob for a while (about 5
rotations), pull up the card set unit
3）If tip of the card protrude little from Gate
unit, move the card to the upper and pull it
to upward and remove.
4） I If tip of the card does not protrude from
Gate unit, close the card set unit as it is and
switch the power from OFF to ON. And
restart print.
(When there is the card at rear part of the
printer).
1）Move the card by finger to the position
shown in the following figure.
2）If the card move to the position shown in
the following figure, pick up the top of the
card and pull it up (as tilt it slightly
forward）, and remove it.
Card
Gate