User Manual

Chapter 4. Error Handling
4-2
Paper Jam
1. Open the drawer unit.
2. Cut off the folded section or printed section
with scissors.
When the paper is folded inside of the printer,
pull it out slowly.
3. Open the open guide unit.
4. Pull out the paper until the paper setting
lamp goes off.
Power Supply Interrupted during Printing
In case, power supply interrupted during the
printing, Thermal Head will be kept pushing to
Platen. Leaving this situation for a long time,
shape of Platen can be warped. In order to avoid
this situation, please follow the instruction
below.
1. Turn off the power of the printer.
2. Turn on the power for 3 or more seconds
after turning off the power.
3. Paper Jam is displayed on the printer
status lamps, open the front cover and
take the necessary action according to
the instruction provided in 4-2, "Paper
Jam".
When the Ribbon is snapped
1. Remove the ink ribbon.
2. Stick the broken part of the ribbon with a
tape.
3. Turn the ribbon on the rewinding side and
rewind the taped section completely.
Attention:
・If the paper is used without cutting off the
folded section or printed section, paper jam
occurs again or the ink ribbon may snap
during printing. Always cut off the
creased section or printed section of the
paper.
・Cut off the paper straight and at right
angles to the roll paper direction.
・If paper jam occurs frequently, a defect in
the mechanical section is assumed.
Consult with the service center.
PAPERSET lamp
Attention:
If the paper is can not pulled out
to the Ribbon side, pull out it to the Roll
paper side following the instruction in Step
3 and Step 4.
If the paper is pulled out to the Ribbon side
by force, the printer may break down.