User Manual

Chapter 1. Important Safety Instruction
1-2
Attention:
At installation, appropriate
interface cable will be required with your
computer.
Warning:
Secure the power cable
firmly.
Warning:
The thermal head
reaches high temperature during
operation but this is normal. Do
not touch the thermal head.
Warning:
Do not attempt to
service the printer beyond the
instruction specified in this
document. In case, impossible to
recover from the problem, please
contact to the dealers or service
center.
Warning: This product must be
grounded, and always used with
only the specified power cable or
the power cable accompanying
this product.
If the product is used without
ground, and current leakage
occurs, fire or electrical shock is
most likely to result, and also
cause signal-receiving
interference to a radio, a
television receiver, and other
similar electric appliances.
If the proper grounding
connection is not possible, please
contact to the dealers or service
center.
Warning:
Do not dismantle or
remodel the printer.
Some sections of the printer
contain a high voltage or become
very hot. Ignoring this warning
may cause electric shock, fire, or
burns.
Handling Instruction
In handling the printer, please pay attention to
the followings;
Warning:
Lift the printer from its
box and put it onto a flat table or
desk.
Warning:
Be careful when you
transport the printer on the
slippery floor.
Warning:
In case you drop the
printer, firstly turn off the power
of the printer and remove the
power cable, then contact the
dealers or service center. To use
the printer without any checking,
can cause the fire or electric
shock.
Warning:
At nearly
1
4
Kg, the
printer is too heavy to be lifted by
one person.
Also please take a good care of
your hands and fingers when
lifting the printer from the box.
Attention:
Touching the surface of the
thermal directly can cause the damage to
thermal head. When a hard object get
into the printer, it can cause the damage to
the printer mechanism. In such case,
please do not use the printer.