User Manual
Chapter 2. Installing and Set Up
2-2
Parts Name and Function
(
Front View
) (
Rear View
)
(Front Internal View) (Upper Internal View)
№
Name Function
①
Printer Status Lamps Printer status display lamps are located on the panel.
②
Drawer Unit
Open the drawer unit when replacing an ink ribbon or paper, or
when performing maintenance.
③
Drawer Lever When open the drawer unit, hold this lever.
④
Power Switch
This switch turns on/off the power of the printer. When the “|”
marked side of the switch is pressed, the power is turned on.
When the “○” marked side of the switch is pressed, the power is
turned off.
<Caution> Once the printer is turned off, wait at least 3 seconds
before turning it on again.
⑤
Power Connector To be used to connect the power cable.
⑥
USB Connector To be used to connect the USB cable.
⑦
Paper Setting Lamp
When setting the paper, insert the paper until the lamp is lit.
When the lamp blinks, remove the paper until the lamp goes off.
⑧
Open Guide Unit
Open the drawer unit when replacing paper, or when performing
maintenance.
⑨
Open Guide Lever When open the open guide unit, hold this lever.
①
②
③
④
⑤
⑥
⑦
⑨
⑧