User Manual

Operation instruction
1. Deleting number and initialization
1) Standby mode (time display mode) ,keep pressing [FUN] till F01 appears.
2) Press [UP] /[DOWN] repeatedly till F06 appears.
3) Keep pressing [FUN] for 3 seconds, the minimum registered number appears on screen.
4) Press [FUN] to move the cursor position, press [UP] /[DOWN] to change the blinked
number and choose the number to be deleted.
5) Press [ENT] ,the number deleted after flashing, and the next registered number appears; if
initializing the receiver, then keep pressing [ENT] until [-----] appears on screen, and then
[000] /[0000] /[000.00] /[0000.0] shows on screen, initialization is done.
6) Keep pressing [FUN] for 3 seconds, [F06] appears on screen.
7) Keep pressing [ENT] 3 seconds back to standby mode. Deleting or initialization is done.
2. Number register( Please initialize before the first registration)
1) Standby mode, keep pressing [FUN] until [F01] shows on screen.
2) Keep pressing [FUN] for 3 seconds, the last registered number [xxx./xxxx./xxx.xx./xxxx.x.] shows
on screen, if no numbers registered, then the screen shows [001/0001/001.01/0001.1] , if
registered numbers get 299,then screen shows the last registered number
[x.x.x./x.x.x.x./x.x.x.x.x.] .
Remarks: The number display mode decided by setting,details please check Page 8
'desplay mode’and Page 7 ‘Digit number display’.
3) Press [FUN] to move the cursor position, press [UP] /[DOWN] to change the blinked number,
if the dot lighten behind the number chosen, means the number is registered already and
can not register again, please press [ENT] to delete the number( if delete success, the dot is
exting uished), then you can register again.
4) press the call button, the receiver rings, the registered number flashing and adding 1
automatically on the screen.
Remarks: If the display mode set is [000] in F8, the last digit add 1 automatically, if the set is
[000.0] , then the flashed digit add 1 automatically.
5) To register more than one buttons, please repeat the 3)-4) after the first one finished.
6) After the completion of registering all numbers, keep press [FUN] till[F01] shows on screen.
7) Keep pressing [ENT] 3 seconds back to standby mode. Registration is done.
3. Prompt mode