Instruction Manual

stitch Pattern
3
Stitch
/ Length
I A/w\-^
ONE-STEP BUTTONHOLES
The One-step Buttonhole Foot allows you to
stitch complete buttonholes for buttons up to
1-1/2 inches in a single step.
NOTE; See page 28 in reference to stitching
complete buttonholes and stitch balance.
Red symbols indicate buttonhole settings
• Stitch; Buttonhole ||
• Stitch Width: Red | (approximately! to 2)
• Needle Position: J,
• Stitch Length: Within
• Stitch Balance: Neutral
• Speed: MIN
• Zig-Zag Plate
• One-step Buttonhole Foot
Preparation
1. Fill bobbin with enough thread to complete
buttonholes. The bobbin cannot be conve
niently filled after the buttonhole foot is at
tached.
2. Attach the zig-zag plate and one-step but
tonhole foot. Then pull down buttonhole
lever.
• To attach one-step buttonhole foot, place
buttonhole foot behind the needle, then
guide it forward. Center the foot under
the shank and lower the presser foot lifter
so that the shank fits over the presser
foot pin. Press presser foot screw down
firmly until foot snaps into place.
3. Set all dials on red symbols as illustrated.
Set the stitch-length dial midway between
6 and 1 2 in the buttonhole area. Use this
setting for your test buttonhole and then in
crease it or decrease it as necessary. See
page 28.
4. Set stitch-balance dial in neutral position.
Adjust if necessary to balance stitch den
sity on right and left sides of the but
tonhole. See page 28.
Stitch Balance
26