User Manual

Raising the Lower Thread

1. Hold upper thread lightly

with left hand and turn hand

wheel slowly toward you so

the needle enters plate.

2., Continue turning hand

wheel and holding upper

thread until needle rises.

Tighten your hold on the

upper thread and bring up

lower thread in a loop.

3. Open the loop with your

fingers, draw approximately

10 cm (4 inches) of both

upper and lower threads

under the presser foot and

place them diagonally to

left.

Removing Thread from Bobbin

1. If there is not much thread left on the bobbin in the

machine, simply pull the thread end through the

needle plate until bobbin is empty.

If there is a lot of thread on the bobbin, remove bobbin,

unscrew the two halves of the bobbin and remove all

the thread. Then tighten bobbin halves securely.