Instruction Manual

3 SEWING SPEED
The machine has a maximum speed of 1,500
SPM. The speed can be controlled by pedal
depression on the controller.
"^The electric motor used for this machine is
a special motor designed for use only with
this machine and should not be used for other
purposes.
9
HOW TO INSTALL THE NEEDLE
With regard to the needles for this sewing
machine, SINGER needle Cat. No. 2053
90/14 can be used for both double chain
stitching and overedging.
(1) For needle installation, first turn the
machine pulley so as to raise the needle
bar up as far as it will go.
(2) Next, loosen the needle clamp screw
(Figure 45), insert the tip of the needle
into the needle hole (Figure 45) on the
presser foot, and insert the needle into
the needle hole of the needle clamp
as far as it will go.
(3) Firmly tighten the needle clamp screw.
*For the direction of inserting the
needle, it is requested that the needle
be set so that the thread guide groove
is facing the front when facing the
machine as shown in Figure 46.
14