Instruction Manual

SETTING UP THE MACHINE
It is important that this sewing machine be set up
in the correct manner before use,
1-1 Correct installation of the motor
• Loosen the two belt cover screws and detach
the belt cover.
• The bracket set screw {Figure 2), bracket set
washer (Figure 2) and the belt are packed in
this set and attached to the machine body
by fastening the set screw while setting the
belt as shown in Figure 3.
Belt tension is considered adequate, if it
bends slightly when pressed by finger as
shown in Figure 4, When the belt tension is
not adequate, further adjust the tension by
moving the belt tension adjusting nut
(Figure 4) to the right or left.
• Replace the belt cover.