User Manual
Table Of Contents
- Instruction Book for the Singer Sewing Machine
- 1. Getting to Know Your Machine
- 2. Getting Ready to Sew
- Choosing and Changing Accessories
- 3. straight Stitching
- -T-
- Needle Thread Tension
- Sewing a Seam
- 4. Zig-Zag Pattern Stitching
- 5. Buttonholes and Buttons
- t;
The Bobbin Thread
Winding the Bobbin
Preparation Steps
1, Raise the presser foot and turn hand wheel toward
you until needle is in highest position.
Z Loosen hand wheel knob A by turning it toward you
with the right hand while holding hand wheel with
the left hand.
3. Place thread spool on spool pin with thread retain
ing slit B on top. (Break paper at the end of spool if
necessary.)
Winding Steps
• Lead thread around bobbin winder tension disc C,
as illustrated, and through small hole in bobbin from
inside out.
• Place bobbin on spindle and move bobbin winder
D to right.
• Hold thread end and start the machine. Cut off
thread end after a few colls have been wound.
• When required amount of thread has been wound
(winding will stop when bobbin is full) stop machine
and cut connecting thread.
• Move bobbin winder to the left and remove bobbin.
• Hold hand wheel and tighten hand wheel knob.
18