Instruction Manual

While holding thread with fingers, pass it between

the tension discs and pull thread down to make

certain it is properly located in between the

tension discs 3.

Thread the eye of the left needle 9.

Note: Use of tweezers in the accessory case will

make needle eye threading easy.

The position of the thread must be behind the

the thread guide.

Draw about 10cm (4 inches) of thread through

needle eye to hang free.

Place the thread to the back, under the presser

foot.

Continue to thread points 4~8.

Note: Slip thread into the middle slot of the thread

guide 5 and into the slot of take-up

lever cover 6.

Then continue by slipping thread into the

middle slot of the thread guides 7 and 8.

Before threading eye of needle, slip thread behind

thread guide located on the bottom of the needle

clamp.

Before threading eye of needle, make sure thread

is located on the bottom ofin front of thread guide

the needle clamp.

Note: For 4 thread overlock left needle: Use needle

Note: For chain stitch :Use needle D.