Instruction Manual

9
8
9
4
5
7
6
3
3
29
Continue to thread points 4~8.
Note: Slip thread into the rear slot on thread
guides 5. Slip the thread into the slot
of the Take-up Lever Cover 6. Slip the thread
into the right slots for thread guides 7 and 8.
Before threading eye of needle, make sure thread is
in front of thread guide located on the bottom of the
needle clamp for Cover stitch.
Thread the eye of the right needle 9.
Note: Use of tweezers in the accessory case will
make needle eye threading easy.
Draw about 10cm (4 inches) of thread through
needle eye towards the rear of the machine.
Place the thread to the back under the presser
foot.
While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.