Instruction Manual

Tc Wind the Bobbin—
Hold hand wheel K with left
hand, and with right hand,
loosen stop motion screw L.
Place bobbin 4 on spindle.
Press bobbin winder 5 down
against hand wheel.
Place spool of thread on
spool pin.
Lead thread through guide 3
on arm of machine.
Pass thread through lower
notch of guide 6 from front
to back and through upper
notch from back to front.
Lead thread from right to
left'through hole in left
side of bobbin.
Hold end of thread and start machine. (End of thread will break off
after a few coils have been wound on bobbin.)
When Bobbin is Full—
# Stop machine, lift bobbin winder away from hand wheel and remove
bobbin. Tighten stop motion screw L.
If the Bobbin Does not Wind Evenly—
Loosen screw which holds thread guide 6 to bed and move guide to right
or left as required. Then tighten screw. If pressure of bobbin winder
pulley M against hand wheel is insufficient for winding bobbin, loosen
screw N, press bobbin winder pulley against hand wheel and tighten
screw N.
Fig. 4. Winding the Bobbin
To Replace the Bobbin and Thread the Bobbin Case—
Fig. 5.
Hold bobbin so that thread leads
off in direction shown.
Place bobbin in case and draw
thread into slot 1.
Draw thread between case and
tension spring until it reaches
notch 2.
Pull about 3 inches of thread
across bobbin.
Fig. 8.
Close slide plate, allowing
thread to enter notch in slide
plate.
To Prepare for Sewing—
Turn hand wheel over toward
you so that needle enters
throat plate and brings up the
bobbin thread.
Fig. 9. Drawing Up the Bobbin Thread