User Manual

Sewing on buttons

Install the darning plate. (1)

Change presser foot to button sewing foot. (2)

Position the work under the foot.

Place the button in the desired position and lower the foot.

Set the pattern selector knob on " " and sew a few securing

stitches. Select one of the two narrow zig-zag patterns

according to the distance between the two holes of the button.

Turn the handwheel to check if the needle goes into the right

and the left hole of the button without hitting the button. Slowly

sew on the button with about 10 stitches.

Select pattern " " and sew a few securing stitches. (3)

If a shank is required, place a darning needle on top of the

button and sew. (4) For buttons with 4 holes, sew through

the front two holes first (3), push the work forward and then

sew through the back two holes. (4)

1 2