Instructions / Assembly

Monogramming with embroidery hoop*

Drop the feed dogs. (Note: Stitch length cannot be controlled

with dial)

- Set the machine as illustrated above.

- Remove the presser foot and the presser foot holder.

- Lower presser foot lever before starting to sew.

- Adjust the stitch width according to the size of lettering or

design.

- Draw the desired lettering or design on the right side of the

fabric.

- Stretch the fabric between embroidery hoop as firmly as possible.

- Place the fabric under the needle. Make sure the presser foot

bar is down in its lowest position.

- Turn the balance wheel towards you to bring up the lower

thread through the fabric. Sew a few securing stitches at the

starting point.

- Hold the hoop with thumb and forefingers of both hands.

- Coordinate sewing speed and movement of hoop.

* Embroidery hoop not included with machine.

Preparation for Monogramming