Use and Care Manual

Sewing on buttons

Move the drop feed control to right side to lower the feed

dogs. (1)

Change presser foot to button sewing foot (2). Select zig

zag pattern " ".

Position the work under the foot. Place the button in the

desired position, lower the foot, adjust stitch width to "3"

and sew a few securing stitches. Adjust the stitch width to

"5". Turn the handwheel to check that the needle goes

cleanly into the left and right holes of the button (adjust the

stitch width according to the button), and slowly sew on the

button with about 10 stitches. Adjust the stitch width to "0"

and sew a few securing stitches. (3)

If a shank is required, place a darning needle on top of the

button and sew (4). For buttons with 4 holes, sew through

the front two holes first (3), push work forward and then

sew through the back two holes. (4)