Owner's manual

SINGER
Inserting a bobbin
• Raise presser foot.
• Turn hand wheel toward you until needle is in its
highest position.
• Open slide plate and remove empty bobbin.
1. Pull 4” (10 cm) of thread from replacement bobbin
and insert bobbin into case, as shown.
2. Holding bobbin in place, guide thread into notch (1)
and then down the slot to the left and guide around
into notch (2).
3. Draw several inches of thread diagonally across the
bobbin toward the back of the machine.
4. While holding thread on outside, close the slide plate,
allowing thread to extend through the slot between
the slide plate and needle plate.