Owner's manual

SINGER
Darning and embroidering stitch
Applications with straight stitching
(With embroidery hoop)
Recommended settings
Needle Position:
Stitch Width:
Stitch Lenght: Any setting
Needle Plate: General Purpose (A)
No presser foot on presser foot shank
Attach feed cover plate (F)
• Insert feed cover plate.
• Trim ragged edges from area to be darned and centre worn
section in embroidery hoop designed for machine use.
• Position hoop under the needle and lower presser bar to
engage tension. Hold needle thread loosely with left hand,
turn hand wheel over and draw bobbin thread up through
fabric. Hold both thread ends and lower needle into fabric.
Take a few stitches to secure. Snip off thread ends close to
fabric.
• Outline area to be darned with straight stitches for
reinforcement.
• Stitch across openning, moving hoop under needle at a
slight angle from lower left to upper right. Keep lines of
stitching closely spaced and even in length. When openning
is filled, cover area with crosswise lines of stitching
This method of controlling fabric movement with an
embroidery hoop may be used to do embroidering or
monogramming.
(4^