User Manual

buttons
♦ Needte Position; ;jUi X J.
♦ Stitch Width: To suit button
♦ S t i t c h L e n g t h : 0
♦ Snap-in Feed Cover
♦ General Purpose Foot
ATTACHtNG A BUTTON
Flat buttons can be sewn on by machine using
the zig-zag stitch.
♦ Attach snap-in feed cover to general pur
pose needle plate.
l.Set stitch width selector at |.
♦ Set needle position at left
♦ Place button positioned on fabric under
foot and lower needle into centre of left
hole.
♦ Lower presser foot>
♦ Turn hand wheel toward you until the ne
edle rises out of button hole and is just
above the presser foot.
2. Set stitch width selector to a medium width
zig-zag setting.
♦ Continue turning hand wheel until the
needle is above right'hole, adjust stitch
width, as necessary, until needle enters
the ceritre of the right hole.
♦ Take six or more zig-zag stitches and
finish with the needle on the left.
3. Move stitch width selector to *
few stitches to fasten threads.
and take a
♦ Pull thread ends through to back of gar
ment knot close to fabric and snip off
loose ends of thread.