Use and Care Manual

Reverse stitch button

Bouton du point de marche arrière

Botón de puntada hacia atrás

Programmable needle up/down button

Touche de position d’arrêt d’aiguille

Nterruptor de posicion de aguja parada

Start/stop button

Bouton de marche/arrêt

Botón inicio/parada

OPERATION BUTTONS

DUAL PURPOSE REVERSE/TACKING STITCH

BUTTON

Reverse stitch function for straight and zigzag stitches (

)

Reverse sewing is carried out while the reverse stitch button

is pushed.

The machine will continue to sew in reverse as long as the

reverse button is pressed.

* Tacking stitch function for tie-off of other stitches ( )

The sewing machine makes 4 tiny tacking stitches to tie

off the sewing on all patterns except straight, zigzag and

buttonhole stitches. The position of the tacking stitches will

be at the exact spot in the pattern where the reverse/tacking

stitch button is pushed.

NOTE: This function is very useful for tying off the

sewing pattern to avoid raveling at the start and end

of sewing.

START/STOP BUTTON ( )

When sewing without having the foot controller connected, the machine starts slowly when the start/stop button is pushed. When

it is pushed again, needle moves and stops at its highest position.

When using foot control, simply press foot pedal with your foot until you reach a slow even speed. The harder you push, the faster

the machine will sew. Release pressure on foot pedal to stop the machine.

PROGRAMMABLE NEEDLE UP/DOWN BUTTON

(

)

Push the switch and LED lamp will be lit red and needle will stop at down position whenever you stop sewing.

Push it again to stop needle at up position.

NOTE: When foot control is connected, start/stop button cannot be used.