Instruction Manual

REMOVING AND REPLACING LIGHT BULB

CAUTION:

• Before changing light bulb, make sure you have removed plug from socket outlet.

Be sure to replace the face plate which covers the light bulb before operating the

machine.

• This machine is designed to use a 15-

watt maximum light bulb.

To change the light bulb, the face plate

must first be removed.

• Loosen and remove screw (1).

• Slide face plate down and away from

machine.

TO REMOVE THE LIGHT BULB

• Push bulb up into socket (2) and turn

to the left to unlock bulb pins.

• Pull bulb down and out of socket.

TO REPLACE THE LIGHT BULB

• Push new bulb up into socket and turn

to the right until pins lock into position.

• Reposition face plate by sliding top

edge of plate under edge of top cover.

• Line up screw hole in plate with screw

hole in machine.

CLEANING THE MACHINE

Your machine is designed to give you many years of dependable service. To ensure this

reliability, take a few minutes to keep the machine clean. How often you clean it depends

on how often you use it.

Using the lint brush, remove lint or dust

from:

Insert screw and tighten.

presser bar

needle bar

machine surface (if necessary,

dampen a soft cloth and use a

mild soap to clean the surface)

Remove needle plate as instructed and

clean exposed area with a lint brush.

- bobbin case (if there is a lot of lint

in this area, remove the bobbin

case for cleaning)