User's Manual

2
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING.
Save these instructions in a safe place for future reference.
1. Use appliance only for its intended use.
2. To protect against risk of electrical shock, do not immerse the iron in water
or other liquids. Never immerse the iron, cable or plug in any liquid.
3. This appliance should always be turned to “OFF” before plugging or unplug-
ging from an outlet. Never yank the cord to disconnect from outlet, always
grasp plug and pull to disconnect.
4. Always disconnect the appliance from the electrical outlet when filling with
water or emptying or when not in use. Do not fill the reservoir with water
before removing the plug from the socket.
5. Do not allow cord to touch hot surfaces. Let the iron cool completely before
storing. Loop cord loosely around iron when storing.
6. Do NOT operate appliance with a damaged cord, or if the appliance has
been dropped or damaged. If electrical cord is damaged it must be replaced
by the manufacturer or authorized service agent to avoid a safety hazard.
7. To avoid the risk of electrical shock, do NOT disassemble the iron. Ship to
the nearest authorized SINGER
®
approved service center for examination
and repair. Incorrect reassembly or repair can cause a risk of fire, electrical
shock or injury when the appliance is used.
8. Not intended for use by children. Close supervision is necessary for any
appliance being used near children. Unsupervised use can result in fire or
personal injury. Do not leave appliance unattended while plugged in, on an
ironing board, or while it is still hot. Do not leave the appliance unnecessarily
plugged in. Disconnect the plug from the socket when the appliance is not
being used.
9. Burns can occur from touching hot metal parts, hot water or steam. Use
caution when you turn a steam iron upside down as there may be hot water
in the reservoir.
10. Never use or rest the iron on an unstable surface. Do not leave the hot iron
touching fabrics or very inflammable surfaces.
11. When iron is hot, never set on an unprotected surface.
12. Do not leave the appliance exposed to outside weather.
SPECIAL INSTRUCTIONS:
To avoid a circuit overload, do not operate another high-wattage appliance on the
same circuit. If an extension cord is absolutely necessary, a 10-amp cord should
be used. Cords rated with less amperage may overheat. Use care to arrange the
cord so that it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS
WARNING: THE POWER CORD ON THIS PRODUCT CONTAINS LEAD, A
CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS
OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER HANDLING.
FOR HOUSEHOLD USE ONLY