ESP18 ENG ESP FRA DIGITAL STEAM PRESS INSTRUCTION MANUAL 10.2012 nstruction Manual_US.
nstruction Manual_US.
nstruction Manual_US.indd 1 ENG INSTRUCTIONS SINGER ESP18 120V ~60Hz max 1500W www.singer.
PLEASE READ THIS MANUAL CAREFULLY BEFORE USING AND KEEP IT FOR FUTURE REFERENCE. IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, especially when children are present, basic safety precautions should always be taken, including the following: READ ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER DANGER - Any appliance is electrically live even when the switch is off. To reduce the risk of death by electric shock: 1. 2. 3. 4. Always “unplug it” immediately after using.
26. Do not allow cord to touch hot surfaces. Let appliance cool completely before putting away. Loop cord loosely around appliances when storing. 27. This appliance must be grounded. Do not alter the plug or attempt to defeat this feature. 28. Before plugging in the steam press, be sure the electrical information on the label agrees with your power supply.
10. The Steam Light illuminates once the unit is ready to produce bursts of steam, providing you with a clear visual indication that you can begin using the Steam Burst Buttons. 11. The Temperature Control Buttons are pushed to select a desired temperature, press (+) Button to select the setting with higher temperature, and press (-) button to select the setting with lower temperature. 12. The Temperature Digits twinkles when the unit is heating up.
OPERATION INSTRUCTIONS 1. Turn the ON/OFF Switch to the ”on” position,the Power Indicator Light illuminates. 2. The HEATING Light comes on, and the Temperature Digits twinkles. Identify the type of fabric you will press and then press (+) or (-)button to select the temperature setting that matches the fabric to be pressed. IT IS BEST TO START WITH THE MOST DELICATE FABRICS FIRST, AS HIGHER HEAT WILL CAUSE DAMAGE TO NYLON AND SILKS. ENG 3. Lay fabric flat on Ironing Board. 4.
Shirts and Blouses 1. Place the shoulder yoke on the Ironing Board first and press. 2. Then place the sleeves on the Ironing Board with the fold parallel to the long seam and press. 3. Place the cuffs on the end of the Ironing board and press. 4. Place the bottom o f the shirt Ironing Board so that you begin pressing the side with the pocket. Pull the shirt towards you as you Press each section. 5. Then finish with the collar of shirt. Pants 1.
Using the Pressing Cushion 1. For garments constructed with details such as darts, curved seams, and shoulder pads, a Pressing Cushion may be used. 2. Use the cushion in areas where no creases are desired or to shape a tailored garment. 3. Place the area to be pressed onto the Ironing Board. 4. Place the Pressing Cushion under the dart, seam, etc. 5. Making sure that the area to be pressed is raised, lower the Pressing Plate until it meets the raised area. 6.
TROUBLE SHOOTING Before taking the unit to a service center, please check the following list of common problems for your issue. PROBLEM Unit fails to steam. Power Indicator Light does not illuminate. Unit fails to steam. Power Indicator Light does illuminate. POSSIBLE CAUSE Unit is not plugged in. Plug into electrical outlet. Household Circuit Breaker/ Ground Fault Interrupter has tripped or blown a fuse. Reset Circuit Breaker/Ground Fault Interrupter, or replace fuse.