Instruction Manual

40
PREPARING THE MACHINE BEFORE
INSTALLING THE HOOP
1. Turn hand wheel counter clockwise (toward you) until the
needle comes to its highest position.
1
ATTACHING AND REMOVING
EMBROIDERY HOOP
1. Raise presser foot and needle, and push up lever (A) of

under it.
¿
To remove, pull the hoop forward to slide it out from
underneath the embroidery foot.
2. Slide the hoop onto the embroidery unit from front to back
until it clicks into place.
¿
To remove, press the hoop release lever and slide the hoop
towards you.
NOTE: Before attaching the small hoop, turn on the power
switch to move the carriage to the ready position.
(A)
2
1
Hoop mounting plate
Carriage
Hoop release lever