Owner's manual

Turn balance wheel towards you to get needle to its highest position.
Raise presser bar and replace regular presser foot, with button sewing
foot as shown in Fig. 23- Drop the feed dog as required for darning
and embroidering. Upper and lower thread tensions rerttain the same
as for ordinary sewing.
Place material or parment together with bo.ton uhder ,h, preaaer
teot ,o that holes In hot.on line op with oblong bole in preaser too,.
Adiuat wrdth O. Z,gz„ ...tcb ,0 permit needle to pas. throogb centre
or holes in button. make sure that needle will stitch in
i,h oower torn the balance wheel bv hand toward, yoo to make
Before sewing with power, lur
tbe centre o. the holes in hottoh.lt the needle bit the bo,ton I, will break.
Then sew ,1.. to .1« «itches to attach hotton.
When attaching foor-hole buttons first sew one
lock thread with two or three plain stitches in last hole.
20. BUTTON SEWING
18-